| Item information | Value |
|---|---|
| GTIN: | 4262472872189 |
| Category: | Sensors |
| Shipping weight: | 0,10 kg |
The SUZUKI DR-Z400 has neither an oil pressure switch nor an oil pressure warning light. The same applies to the DR-Z4S and the DR-Z4SM. A drop in oil pressure therefore goes unnoticed while riding.
This add-on package provides the missing monitoring. The sensor is screwed in place of the blanking plug on the right-hand side of the engine case – the measuring point specified by SUZUKI for checking oil pressure. The measured pressure is shown on the CUMPAN Cockpit Assistant.
Measurement is continuous across a range of 0 to 10 bar. The warning threshold is set freely in the CUMPAN; if the pressure falls below it, the oil pressure is highlighted in red on the display.
Benefits
- Oil pressure monitoring on an engine without a factory oil pressure display
- Continuous measurement with cold and warm engine oil
- Early detection of low oil level through a drop in pressure
- During prolonged riding on the rear wheel the oil flow can break away – the pressure drop becomes visible
- Oil dilution caused by fuel entry becomes apparent through falling oil pressure
- No modification to the standard wiring
Technical Data
- Measuring range: 0 to 10 bar
- Specified value according to SUZUKI: 0.4 to 1.4 bar at 60 °C oil temperature and 3,000 rpm
- Thread, engine side: M12×1.125
- Thread, sensor side: M10×1
Compatibility
- SUZUKI DR-Z400 E (all model years)
- SUZUKI DR-Z400 S (all model years)
- SUZUKI DR-Z400 SM (all model years)
- SUZUKI DR-Z4S (all model years)
- SUZUKI DR-Z4SM (all model years)
In the box
- 1× oil pressure sensor
- 1× connection electronics for the oil pressure sensor
- 1× thread reducer M12×1.125 to M10×1
- 1× Presslok™ single-wire connector with gel filling
- 1× ACC extension cable 50 cm
- 1× ACC splitter
Video
BEROTEC GmbH, Gewerbestr. 13, 75057 Kürnbach, Deutschland, info@berotec.de, https://berotec.de